
-
CoolAge Orb X120 Transform X120TF CPU Heatsink Cooler
Author: Rhys Published: September 2nd, 2009 3:32 PM Category: CPU Coolers,Reviews
Installation
Preparing the Coolage 120TF for installation was incredibly simple. Firstly, I installed the LGA1366 mounting clips to the base of the heat sink using the four provided screws.
I then removed the self-adhesive backing from the back plate and positioned it properly on my Asus P6T SE motherboard so the holes in the board aligned correctly with the back plates.
Soon after, I screwed the spring-loaded screws on the mounting clips into the holes in the back plate. Once tightened up the heat sink was very secure to my motherboard with no wobble at all.
Lastly, I installed a Coolage 120 SX-2 fan to the cooler using the two provided fan clips. These are slightly different to your standard fan clips and are much easier and less painful to install (and remove).
PLEASE NOTE: A fan is not included with the Coolage X120TF, however, any 120mm will fit.









